Yamabiko Power Blower PB 9010H

1. Close choke (COLD START position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area.

2. Remove air filter cover, foam pre-filter, and air filter. Brush dirt from inside cover.

• Clean foam pre- filter (A) in water/detergent solution and rinse with clean water.

• Wrap the foam pre-filter in a clean, dry cloth and squeeze (do not wring) dry. Allow to dry completely before reuse. Do not oil.

• Lightly brush debris from air filter (B).;

MAINTENANCE PROCEDURE NOTES: Replacement is recommended based on the finding of damage or wear during inspection.

Check unit for loose/missing nuts, bolts, and screws.

Tighten and/or replace as needed.

Sign off on the bolt inspection

NOTICE: To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carries combustion heat away from the engine.

Overheating and engine seizure can occur when:

• Air intakes are blocked, preventing cooling air from reaching the cylinder.

• Dust and grass build up on the outside of the cylinder. This build up insulates the engine and prevents the heat from leaving.

Removal of cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance.” Any failure attributed to lack of maintenance is not warranted. Clear Debris

1. Brush accumulated debris from intake grill and other cooling passages.

1. Disconnect spark plug lead from spark plug.

Check unit for loose/missing nuts, bolts, and screws.

Tighten and/or replace as needed.

Sign off on the daily nuts inspection

Check unit for loose/missing nuts, bolts, and screws

List any loose/missing nuts, bolts, and screws found

Tighten and/or replace as needed

List any parts that were tightened or replaced

Sign off on the daily screws inspection