Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Yale Material Handling Corporation Pallet Truck MPW060

Create an account to install this asset package.

Maintenance Plans for Yale Material Handling Corporation Pallet Truck Model MPW060

Integrate maintenance plans directly into your work orders in MaintainX.

1 Daily Battery Electrolyte Level Inspection

Warning: Always use distilled water for battery maintenance.

Is the electrolyte level within the correct limits?

If the electrolyte level is below the top of the separators, the cell can be damaged.

Note down any observations during the check.

Upload a photo of the electrolyte level.

Sign off on the daily battery electrolyte level inspection.

Run this procedure

2000 Hourly Pallet truck Maintenance

Warning: This maintenance check requires trained personnel with PPE!

Load Wheel Bearings - Disassemble, clean and inspect for wear or damage

Comments on Load Wheel Bearings inspection

Drive Unit Gear Oil - Drain and replace gear oil

Comments on Drive Unit Gear Oil replacement

Hydraulic System - Clean and inspect strainer

Comments on Hydraulic System inspection

Hydraulic Tank - Empty, clean, and refill hydraulic oil

Comments on Hydraulic Tank maintenance

Run this procedure

2000 Hourly Pallet Truck Maintenance

Drain and Refill:

- Hydraulic Tank Fluid Level-Check Level

- Differential Gear Oil Level

- Drive Unit Oil Level

CO-Complete Overhaul:

- Lift and Tilt Cylinders for Leaks and Proper Operation

Replacement:

- Hydraulic Tank Breather

Visual Inspection, Test and Adjust as Required:

Run this procedure

350 Hourly Pallet Truck Check

Visual Inspection, Test and Adjust as Required:

LUBRICATION CHECK:

- Blow off, Clean When Necessary and Inspect for Damage.

- Lubricate-Chassis (All Fittings)

- All Linkage

- Friction Surfaces on Mast

- Friction Surfaces on Attachment

- Clean and Lube Lift Chains

- Differential Gear Oil Level

Run this procedure

350 Hourly Pallet Truck Maintenance

Warning: Care must be taken when greasing brake shoe pivot pins. Do not allow grease to get on brake linings which can cause brake failure. Make sure lube fittings are thoroughly wiped clean of all grease when lubricating these pivot pins. DO NOT OVER LUBRICATE.

Control Handle-Pivot Shaft lubricated?

Drive Unit Bearing-Access Holes in Drive Unit Compartment lubricated?

Load Wheel Axle-Raise Forks MPW (Corrosion Only) lubricated?

Brake Shoe Pivot Pins-Remove Drive Unit Cover lubricated?

Brake Cam-Remove Drive Unit Cover lubricated?

Lift Linkage,MPW - 22, MLW - 8 lubricated?

Brake Roller-Linkage lubricated with engine oil?

Brake Cam and Roller Assembly greased?

Run this procedure