Vulcan Heavy Duty Gas Griddle MSA36-10

Check all gas joints disturbed during servicing for leaks using a soap and water solution.

Turn the gas supply off at a manual shutoff valve.

Remove the pressure tap plug and attach manometer.

Griddle Level Calibration Procedure

Describe the initial level condition of the griddle

Adjust legs by turning the bullet feet at the bottom of each leg

Record the adjustments made to each leg

Is the griddle level after adjustment?

Ensure legs are not extended more than 1-¾”

Disconnect the electrical power to the machine and follow lockout / tagout procedures

Shut off the gas before servicing the unit and follow lockout / tagout procedures

Remove screw securing pilot assembly bracket from underneath the front of the griddle

Carefully lift to disengage bracket from slot and work assembly down to access parts

Center pilot in flash tube opening and align ignition ports with both sides of flash tube

WARNING! Disconnect the electrical power to the machine and follow lockout / tagout procedures

Turn all thermostats to off position

Loosen set screw securing thermostat knobs

Remove screws securing front panel to griddle

Pull front panel forward and lay aside

If servicing a 900RX, lay front panel face down in front of unit

Check line-of-sight through the front panel to see both pilot burners and griddle burners

Observe and record temperatures at the center points of the cooking zones using a Surface Probe

Thermostat Setting and Stabilization

Set thermostats to 350°F and allow to stabilize

Temperature Recording and Calculation

Record the temperature tester readouts for each zone for 3 cycles

Calculate total average temperature for each zone

Is the temperature within 350°F ±15°F?