Still Electric Pallet Truck EXU-H20

Clean and blow out the electrical plate

Check the mounting of the electrical connections

Check the condition of the on-board charger

Check that the cables and fuses are secure

Check and adjust the battery electrolyte level

Clean the sensors for the automatic lifting function

Sign off on the electrical equipment maintenance

Check the error codes (using the diagnostic tool)

Check that the cables and bundling are in good condition

Check the hydraulic system for leaks

Check the general condition of the forks and the chassis

Check that the cables and bundling are in good condition

Sign off on the Electric Pallet Truck Check

Switch off the ignition and pull the emergency stop handle

Pull back the cover of the technical compartment (see description in ′′Access to the technical compartment′′)

Is the oil level in the centre between the minimum and maximum marks on the tank?

Replace and tighten the plug afterwards

CAUTION! Only use hydraulic oil that complies with the specifications (see lubrication table);

Always park the truck as specified

Disconnect the battery connector (4)

CAUTION! Disconnect the battery connector when washing the truck

Truck exterior cleaned with water and cleaning agents soluble in water

Oil filler openings and the surrounding area cleaned

Required assemblies greased (mast, controls and joints)

WARNING! Do not aim the steam cleaning device directly on electric motors and other electric components, brakes and bearings

Electrical components cleaned with a non-metallic brush and blow dry with a weak jet of air

Truck dried thoroughly (eg with compressed air)

Warning: This maintenance check requires trained personnel with PPE!

Check the tyres and the wear on the wheels and rollers

The tyre tread on the drive wheel (1), the stabilising wheel (2) and the rollers (3) must not be damaged

Replace damaged or worn wheels with new wheels, and damaged or worn rollers with new ones

CAUTION! A wrongly adjusted stabilising wheel can lead to stability problems. This adjustment must be carried out by our service department

Adjusting the height of the stabilisers

Lower the stabilisers to stabilise the truck

Lift the stabilisers if the truck often encounters obstacles and if grip must be improved

Loosen the lock nut (2) (36 spanner) by holding the ball bearing (3) by its flat surface (36 spanner)