Still Electric Pallet Truck EXU-20

Check that the cable insulation is undamaged and that there are no signs of overheating at the connections

Check that the '+' and '-' output terminals are not sulfated (presence of white salt)

Check the condition of the power outlet contacts and the presence of the keying pin

Check the condition of the locking tab on the battery connector

CAUTION! The points mentioned above can cause serious incidents. In the event of a fault, please contact the After-Sales Service;

Sign off on the electrical equipment check

Check the error codes (using the diagnostic tool)

Check that the cables and bundling are in good condition

Check the hydraulic system for leaks

Check the general condition of the forks and the chassis

Sign off on the Electric Pallet Truck Check

Switch off the ignition and pull the emergency stop handle

Pull back the cover of the technical compartment (see description in ′′Access to the technical compartment′′)

The oil level is in the centre between the minimum and maximum marks on the tank for correct use of the truck functions

Replace and tighten the plug afterwards

CAUTION! Only use hydraulic oil that complies with the specifications (see lubrication table)

Sign off on the hydraulic oil level check

– Always park the truck as specified

– Disconnect the battery connector (4)

CAUTION! Disconnect the battery connector when washing the truck

Washing the exterior of the truck

WARNING! Do not use inflammable fluids for cleaning. Observe the above safety precautions for preventing sparks through shorts (disconnecting the battery connector). When the truck is being cleaned, carefully cover all vulnerable components, particularly electric components. Observe the manufacturer’s instructions for handling the cleaners

1. Clean the truck exterior with water and cleaning agents soluble in water (sponge, rags)

2. Clean especially the oil filler openings and the surrounding area

3. Grease the required assemblies (mast, controls and joints)

Warning: This maintenance check requires trained personnel with PPE!

Check the tyres and the wear on the wheels and rollers

The tyre tread on the drive wheel (1), the stabilising wheel (2) and the rollers (3) must not be damaged

Replace damaged or worn wheels with new wheels, and damaged or worn rollers with new ones

CAUTION! A wrongly adjusted stabilising wheel can lead to stability problems. This adjustment must be carried out by our service department

Adjusting the height of the stabilisers!

NOTE! Adjusting the clevis (1) with new drive wheel and stabiliser wheels R = 22 mm

Lower the stabilisers to stabilise the truck

Lift the stabilisers if the truck often encounters obstacles and if grip must be improved