Pentair Centrifugal Pump P6E6G-208L

Describe any safety concerns observed during maintenance

Use a low pressure (below 5 PSI), high volume blower for air purging

Drain all water from pump and piping when expecting freezing temperatures or when storing pump for a long time

Keep motor dry and covered during storage

Ensure pump is not covered with plastic to avoid condensation/corrosion problems

Inspect all covers for cracks, damage, and advanced weathering.

Is any cover loose, cracked, damaged, broken, or missing?

Immediate Actions if Issues Found

Close the pool or spa immediately.

Post a notice about the closure.

Keep the pool or spa closed until an appropriate certified cover is properly installed.

Replace drain covers as necessary due to deterioration from sunlight, pool chemicals, and weather.

Turn OFF power to motor before draining pump

Pump down water level below all inlets to the pool

Use low pressure air to blow accumulated water from the piping system

Cap inlet piping after draining to keep water out of the pipes

Remove trap cover and drain the tank body through the drain plugs

Ensure the pump is stopped and all valves in suction and discharge are closed.

Confirm all pressure is released from the system before proceeding.

Verify the strainer pot temperature is cool to touch before opening.

Remove trap cover handle ring by turning counterclockwise. Use a rubber mallet if necessary.

Remove and clean the strainer basket. Ensure all holes are clear and flush with water.

Reinstall the strainer basket with the large opening at the pipe connection port.

Inspect the lid O-Ring and reinstall on trap.