Pace Central Filter Unit Arm-Evac 250

Power source turned off before opening the Arm-Evac 250

Arm-Evac and accessories protected from dampness

Arm-Evac 250 not extracting water vapor or steam

Arm-Evac 250 operated with filters

Arm-Evac 250 and ducting hoses not blocked

No extraction of corrosive compounds without checking with PACE

Re-calibration of the Arm-Evac 250 after a filter change out or system configuration change

General Tips: Before opening the Arm-Evac 250, always turn off the power source. Protect the Arm-Evac and accessories from dampness. Do not extract water vapor or steam. The Arm-Evac 250 must not be operated without filters. Impurities in the extracted air can damage the motor pump. Do not allow the Arm-Evac 250 or ducting hoses to become blocked. Do not extract corrosive compounds without checking with PACE. Re-calibrate the Arm-Evac 250 whenever a filter change out or system configuration change occurs.

Pre-Filter: This filter removes coarse particles from the air. In general, the pre-filter must be changed on a monthly basis. However, depending on your particular process, the filter may need to be changed more or less frequently.

Main Filters: Fume Extraction Filters remove particulates from the air and capture noxious odors and gases. Depending on your particular process, the filter cartridge may need to be changed more or less frequently.

Turn the Power Switch to the Off (“0”) position.

Remove the Filter access cover.

Remove the old Filter Cartridge(s).

Install new Filter(s). Insure that the Pressure Tube (black coiled cable inside filter compartment) does not become kinked when the new Filter is installed. Insure that the airflow arrow on Filter cartridge is pointing downward.

Before opening the Arm-Evac 250, always turn off the power source.

Protect the Arm-Evac and accessories from dampness.

Do not extract water vapor or steam.

The Arm-Evac 250 must not be operated without filters. Impurities in the extracted air can damage the motor pump.

Do not allow the Arm-Evac 250 or ducting hoses to become blocked.

Do not extract corrosive compounds without checking with PACE.

Re-calibrate the Arm-Evac 250 whenever a filter change out or system configuration change occurs.

General Tips: Before opening the Arm-Evac 250, always turn off the power source. Protect the Arm-Evac and accessories from dampness. Do not extract water vapor or steam. The Arm-Evac 250 must not be operated without filters. Impurities in the extracted air can damage the motor pump. Do not allow the Arm-Evac 250 or ducting hoses to become blocked. Do not extract corrosive compounds without checking with PACE. Re-calibrate the Arm-Evac 250 whenever a filter change out or system configuration change occurs.

Accessories: Monthly cleaning of the Arm-Evac 250 extraction accessories is recommended. Arm-Evac accessories should be cleaned with a non-aggressive cleaning solvent or detergent only. Make sure the Arm-Evac accessories are completely dry before re-use.

Power source turned off before opening the Arm-Evac 250?

Arm-Evac and accessories protected from dampness?

Arm-Evac 250 operated without filters?

Arm-Evac 250 or ducting hoses blocked?

Corrosive compounds extracted without checking with PACE?

Arm-Evac 250 re-calibrated after a filter change out or system configuration change?

Arm-Evac accessories cleaned with a non-aggressive cleaning solvent or detergent?