Outback Sleepers Moulds KEN-0514 (STD/HD 2.0m)

Warning: Do not scrub the sleeper or use a high-pressure hose as it can damage the surface.

Remove dust or dirt by lightly running a hose over the affected area.

Regularly brush the top of the sleeper wall to prevent dirt and dust build up.

Is the site particularly muddy and unprepared?

If yes, cover the face of the sleepers with plastic sheeting to prevent wind from blowing excessive dust.

When cutting our products, adhere to the following points.

Use Quick Cut Saws with a Masonry or Diamond blade for cutting sleepers and UFPs.

Wash the cut end of the sleeper with a light garden hose to remove the surplus by-product.

Warning: Do not use a pressure hose to wash the sleeper.

Follow the installation guides in our Product Guide on how to build your retaining wall.

Used plastic (Forticon) behind the sleepers before backfilling the wall.

Used an Agi drain at the base of the wall to allow drainage.

DO NOT scrub the face of the sleepers to remove dirt or stains. Use a light garden hose to soften the dirt or stain and remove by hand (if possible).

DO NOT use a pressure hose to clean the sleepers / UFP's.

DO NOT subject the concrete sleepers / UFP's to excessive water hitting the face from a sprinkler system.

DO NOT use any chemical solutions to clean the sleepers (other than Efflorescence Remover).

Sign off on the moulds maintenance