

Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Mitsubishi HVAC Unit NTXMSM48A182AA
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
Electrical Part Box Removal
Panel Removal
Remove the service panel. (See Photo 1)
Remove the top panel. (See Photo 1)
Disconnect the connecting wire from terminal block.
Remove all the following connectors from multi controller circuit board
Pull out the disconnected wire from the electrical parts box.
Compressor Lead Wire Disconnection
Remove the terminal cover. (See Figure 1)
Disconnect the compressor lead wire from the comp. terminal. (See Figure 1)
Linear Expansion Valve LEV-A / LEV-B Removal
Panel Removal
Remove the service panel. (See Photo 1)
Remove the top panel. (See Photo 1)
Remove the cover panel (front). (Refer to procedure 8 (5))
Remove the cover panel (rear). (Refer to procedure 8 (6))
Remove the side panel (R). (Refer to procedure 8 (7))
Component Removal
Remove the linear expansion valve coil. (See Photo 11,12)
Remove the electrical parts box. (See Photo 5)
Compressor MC Removal
Panel Removal
Remove panels
Cover and Electrical Parts Removal
Remove 2 front cover panel fixing screws (5 x 12) and remove the cover panel (front) (See Photo 4)
Remove the electrical parts box (See Photo 5)
Valve Bed and Separator Removal
Remove the valve bed (Refer to procedure 8 (4))
Remove 3 separator fixing screws (4 x 10) and remove the separator (See Figure 2)
Refrigerant Recovery and Compressor Removal
High Pressure Switch 63H / High Pressure Sensor 63HS Removal
Panel Removal
Remove the service panel. (See Photo 1)
Remove the top panel. (See Photo 1)
Remove the cover panel (front). (Refer to procedure 8 (5))
Remove the cover panel (rear). (Refer to procedure 8 (6))
Remove the side panel (R). (Refer to procedure 8 (7))
Component Disconnection
Pull out the lead wire of high pressure switch and high pressure sensor.
Remove the electrical parts box. (See Photo 5)
Thermistor Outdoor Liquid Pipe TH3 / Thermistor Compressor TH4/ Thermistor Hic Pipe TH2 Removal
Panel and Connector Removal
Remove the service panel
Disconnect the connectors on the multi controller circuit board
Thermistor Removal
Pull out the thermistors from the sensor holder
MaintainX Assist is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













