Life Fitness Training Machine Pro 2 PSSLP

• Clean guide rods with a cotton cloth.

Clean Guide Rods with paint thinner on a cloth and wipe off old residue.; Clean tops of bearings at stack and inspect for heavy buildup on rods below head plate (lift half of stack and do a visual inspection, then clean as necessary).

• Inspect hardware should be checked for looseness. Tighten as required using metric tools.

Inspect hardware on all machines and tighten any bolts or nuts that may have loosened over the life of the product.; NOTES

• Use polishing compound (such as car wax) to clean and remove shoe scuffs from powdercoated surfaces as necessary.;

Clean upholstery with a mild soap and water

Inspect cables for wear or damage and proper tension (should not exceed ¾” deflection). Pay close attention at bends and attachments points.

Use polishing compound (such as car wax) to clean and remove shoe scuffs from powdercoated surfaces as necessary.

Sign off on the daily training machine maintenance

Clean hand grips with mild soap and water.

Wax frames with a standard, non-abrasive, wax finish.

Inspect paint for damage. All paint chips should be filled immediately with touch-up paint.

Lubricate guide rods with Break-Free (part number SK50-P0005-0000). Apply the Break-Free to a cotton cloth, then run the cotton cloth up and down the guide rods as needed.

Use polishing compound (such as car wax) to clean and remove shoe scuffs from powdercoated surfaces as necessary.

Visually inspect all hardware for loosening, tampering or wear

Check jam nut on weight stack for tightness

Inspect all accessory and or carabiner clips or connecting links for wear

Check cables for stretch and adjust as necessary by loosening the large nut on top of the weight stack and screw in the threaded plug until cable is tight and the weight stack pin goes in all holes easily. Tighten the large nut to complete the adjustment

Sign off on the machine maintenance