Kaeser Portable Compressor (Mobilair) M82

Warning: This check requires trained personnel with PPE!

Generator bearings check passed?

Choose the type of service required

Sign off on the generator bearings check

Clean dust evacuator valve on engine air filter

Check engine air filter maintenance indicator

Check/empty the fuel water separator

Check compressor air filter maintenance indicator

Check the exhaust system for leaks, including the exhaust gas after-treatment components

Check the oil level in the tool lubricator

Slowly unscrew and withdraw the oil filler plug

Wipe off the dipstick with a lint-free cloth or rag and screw the plug fully in again

Unscrew and withdraw the plug once more and read off the oil level on the dipstick

Oil level at the upper third of the dip stick: Oil level is correct

If oil does not reach this level: Immediately replenish tool oil

Place the receptacle under the combination filter hose lines

WARNING: Before performing any maintenance function, switch main disconnect switch to "off" position to assure no power is entering unit. "Lock Out" or "Tag Out" all sources of power. Be sure all air pressure in unit is relieved. Failure to do this may result in injury or equipment damage.

Release the retaining clip. Remove the filter cap and take out the filter element.

Carefully clean the inside of the filter housing, the cap and sealing faces with a damp cloth.

Use dry compressed air (≤ 30 psi!) at an angle to blow dust from the element from inside to outside until no more dust appears.

Inspect the element carefully for any damage. If the filter element is damaged: Replace the filter element.

Insert the cleaned or new filter element into the filter housing. Make sure it is properly secured and its gaskets are sealed.

Replace the cap and secure with the clips.

Release the retaining clamps, lift off the cap an extract the air filter.

Carefully clean the inside of the housing, the cover and sealing faces with a damp cloth.

Warning: This maintenance check requires trained personnel with PPE!

Change the oil separator element:

Oil separator element and the sealing ring removed?

Contact surfaces of enclosure and cover cleaned with a lint-free cloth and any adhering oil and grease residue removed?

New oil separator element and new sealing ring inserted?