John Deere Tractor 7730

Lubricate new filter seal with hydraulic oil

Install filter until gasket contacts surface. Hand tighten additional 1/2 turn

Check oil level and add oil as required

Service Air Intake System and Pre-Cleaner

Slide band (A) toward front of tractor

Adjustment of Engine Valve Clearance successful?

Inspection of Crankshaft Vibration Dampening Pulley successful?

Inspection of Flywheel Torsional Damper successful?

Inspection of Drive Shaft Universal Joints successful?

Sign off on the 2000 Hourly Maintenance

Lubricate MFWD Kingpins, Tie Rod Ends and Axle Pivota and Lubricate Triple-Link Suspension (if equipped)

Lubricate Front and Rear PTO Shafts

Check Torque on Wheel and Wheel Weight Bolts

Lubricate Non-Driving (2WD) Axle, Wheel Bearings, Tie Rod Ends, Axle Pivot and Steering Spindles/Cylinder Ends

Clean Cab Air and Recirculation Filters

Replace Transmission-Hydraulic Filters

Clean exterior of filter and mounting area

Open drain valve (B) and drain fuel

Lift up and rotate retaining ring (A) counterclockwise. Remove ring with filter

Install filter assembly. Tighten retaining ring

Replacing Water Separator Filter

Clean exterior of filter and mounting area

Open drain valve (C) and drain fuel

Drain Water from Fuel Filter or Water Separator

Check Transmission-Hydraulic Oil Level

Lubricate MFWD Axle, if Equipped with AutoTrac System

Drain Trailer Air Brake Air Tank (if equipped)

Check Tire Inflation Pressure (Weekly)