Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more
John Deere Tractor 6190R
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
500 Hourly Maintenance
Check that all accessible ground cables are secure
Engine - Check drive belt for wear
Engine - Change engine oil filter
Engine - Change engine oil
Drain oil with engine shut off, but with engine oil still warm.
Fuel system - Change fuel filter
Always change the two filters at the same time.
Have brake system bled and checked by a John Deere™ dealer
Lubricate the draft link bearings (if equipped)
6000 Hourly Maintenance
Cooling system - Change the coolant (if COOL-GARD™ II is used and annual check)
On tractors with cab, is the heater control turned as far as it will go to the right?
Is cap (A) unfastened and taken off?
Is a container placed under the drain to collect the coolant as it emerges?
Is drain plug (C) opened and coolant drained out?
Is drain plug (C) closed and tightened to the specified torque?
Fill the system up to the max. mark (B) with clean water
Is the engine run until it reaches operating temperature?
Is the engine shut off and system drained?
1500 Hourly / 2 Yearly Maintenance
Accumulator on TLS front-wheel drive axle
Nitrogen pressure checked by a John Deere™ dealer?
Front axle without front-wheel drive
Clean wheel hubs and apply new grease?
Engine
Replace filter on crankcase vent (oil separator)?
Transmission/hydraulic system
Change the oil?
Transmission/hydraulic system - Steps
Yearly Maintenance
Inspect seat belt for damage and ensure proper working order
Use coolant test strips to check engine coolant
Inspect hydraulic hoses
Engine - Check drive belt for wear (or every 500 hours, whichever occurs first)
Change engine oil (or every 500 hours, whichever occurs first)
Front loader - Mounting frame, check torques of attaching screws (or every 500 hours, whichever occurs first)
Change activated carbon filters of cab, if equipped (or every 500 hours, whichever occurs first)
Sign off on the yearly maintenance
250 Hourly Maintenance
Access the diagnostic trouble codes, rectify fault and then delete the codes
Check neutral start circuit
Check the Neutral Start Circuit - AutoPowr™/ IVT™ Transmission
Check the Neutral Start Circuit - DirectDrive Transmission
PTO actuation - Check safety device
Lights - Check settings of headlights
Load center - Visual inspection, and clean
Fuel system - Drain water and sediment from fuel tank
Front axle without front-wheel drive - Tighten screws
MaintainX CoPilot is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX