John Deere Tractor 6130D

Inspect engine air intake filters

Clean primary element when indicator on instrument panel illuminates or every 250 hours

Check rubber seal around filter element for cracks and holes

Secondary filter element (B) should only be removed when being replaced

Reinstall primary element with rubber seal first (arrows on label pointing into filter housing)

Check oil level in MFWD axle and wheel hubs

Inspect and clean fuel tank filler cap

Move rockshaft lever full forward to lower hitch all the way down

Replace transmission-hydraulic oil filter

Remove cap (B) and fill system with oil as specified in Fuels, Lubricants and Coolant section

Check oil level at sight glass (A) after filling

Start engine and operate for five minutes

Shut off engine and check oil level. Add oil if necessary

Battery wiped with a damp cloth?

Connections cleaned and tightened?

Battery cover installed and hood lowered?

Specific gravity of electrolyte in each cell

Drain, flush and refill engine cooling system

Enter the engine's hour meter reading

If engine's hour meter reading is 5000 hours or more, or if it has been 5 years since the last thermostat test or replacement, proceed with the next step

Check level in coolant reservoir BEFORE starting tractor.

If engine is COOL and level is below MIN COLD mark, remove cap and add coolant to reservoir to bring level between MIN and MAX COLD mark.

Connect a small hoses to end of drains (B).