John Deere Sprayer R4060

Are solution tank straps loose?

Lock nuts loosened if straps were loose

Straps tightened and nuts turned additional two turns if straps were loose

Lock nuts tightened if straps were loose

Sign off on the 10 Hourly Maintenance

Remove cap screw (A) and access cover (B)

Remove cap screws (A) and shield (B)

Visually inspect for missing retaining rings and premature wear of the cross and bearings assemblies (A)

Check shaft (B) for play in vertical, horizontal, or radial direction

If any of these conditions exists, see your John Deere dealer or qualified service provider

Sign off on the 3000 Hourly Inspection

Replace open crankcase ventilation Final Tier 4/Stage IV machines only

Replace Open Crankcase Ventilation Filter (Final Tier 4/Stage V 6.8 L Engine)

Pull hood release (A) and raise hood.

Remove open crankcase ventilation filter from inside the filter housing (B).

To install new filter, align tabs on the new filter with tabs on inside of the filter housing.

Replace Open Crankcase Ventilation Filter (Final Tier 4/Stage V 9.0 L Engine)

Change planetary hub oil-R4030, R4045, and R4060

Drive machine at 40 km/h (25 mph) or above for 15 —20 minutes.

Park machine on a flat, level surface.

Allow hubs to cool to a point that the oil can be handled safely (approximately 30 minutes).

Rotate hub until casting arrow is pointed to two o'clock position (A)

Remove drain plug (B) and drain oil into a suitable container.

Reinstall drain plug. Tighten to specification.

Replace air compressor air dryer cartridge

Air system pressure relieved by opening valve (A)

Desiccant cartridge (A) removed and discarded

O-ring (B) from the adapter plate stud removed and discarded

Top surface of the adapter plate and threaded stud cleaned

Light coat of grease applied to O-ring and installed on the adapter plate

Generous coat of grease applied to the surface of the new desiccant cartridge gasket