Ingersoll Rand Diaphragm Pump PD10E-FES-PTA

Inspect all parts for wear or damage

Lubricate diaphragm rod with Lubriplate FML-2 grease

Lubricate 'U' cup with Lubriplate FML-2 grease

Install Santoprene diaphragm with 'AIR SIDE' towards pump center body

Valve Block and Adapter Plate Removal

Adapter Plate and Valve Insert Removal

Insert a small flat blade screwdriver into the notch in the side of 135 valve block

Push in on tab to remove 233 adapter plate

Provide a clean work surface to protect sensitive internal moving parts from contamination.

Keep good records of service activity.

Include pump in preventive maintenance program.

Empty captured material in the outlet manifold by turning the pump upside down to drain material from the pump.

Inspect and replace old parts with new parts as necessary

Check for deep scratches on surfaces, and nicks or cuts in 'O' rings

Take precautions to prevent cutting 'O' rings upon installation

Lubricate 'O' rings with Lubriplate FML-2 grease

Do not over-tighten fasteners, refer to torque specification block on view

Re-torque fasteners following restart

Use tool # 204130-T for installation of (168) 'O' rings onto the (167) pilot piston

Tap on (118) to expose the opposite (121) sleeve, (167) pilot piston and other parts.

Inspect inner bore of sleeve for damage.