Ingersoll Rand Air Compressor R110IU-140

Is the coolant visible in the sight glass while the machine is running on load?

Is the coolant level between the middle and the top of the green section of the sight glass?

Did you run the compressor for a minimum of 40 seconds before stopping?

Did you add coolant until the level is up to the mid-point of the sight glass?

Any leaks, dust build up or unusual noise/vibration?

If any issues were found, describe them here

Check the cooler(s) for build up of foreign matter

Cleaned the cooler(s) if necessary?

On water cooled and sea water cooled models, check the water input line strainer for build up of foreign matter

Cleaned the water input line strainer if necessary?

Operate the safety valve manually to verify that the valve mechanism is functioning correctly and that a small amount of air is released.

Check all hoses for signs of deterioration, cracks, hardening etc.

Replace all hoses every 4 years.

Sign off on the air compressor check

Warning: Only trained personnel should perform this procedure.

Position a suitable container under the drain plug.

Drain plug positioned correctly?

Remove the plug and completely drain the coolant.

Remove additional coolant from the airend discharge tube and oil coolers from their respective plugs.

SSR Food Grade Coolant is a polalphaolefin base coolant.

Change every 1000 hours or every 6 months, whichever comes first.

Do not operate unit past this 1000 hour change interval, as coolant degradation will occur.

Enter the current operating hours of the unit

Enter the date of the last coolant change

Was the coolant replaced within the specified interval?

Upload a photo of the new coolant bottle

Sign off on the coolant replacement