Hyundai Forklift 45D-7E

Warning: This maintenance requires trained personnel with PPE!

Hydraulic oil return filter replaced

Oil changed after removing drain plug on tank bottom

Truck for obvious damage and leaks

Warning plates and decals condition

Lift chain and fastener condition

Warning: This inspection requires trained personnel with PPE!

Visual check for obvious damage

All capacity, safety, and warning plates or decals are attached and legible

Check for leaking fuel, engine coolant, transmission fluid, etc.

Check for hydraulic oil leaks and loose fittings

Driver's overhead guard, load back rest and all other safety devices are in place, securely fastened and undamaged

Check all of the critical components that handle or carry the load

Inspect the mast and lift chains

Inspect the load forks for cracks, breaks, bending, twists, and wear

(1) These are the parts which the operator cannot judge the remained lifetime of them by visual inspection.

(2) Repair or replace if an abnormality of these parts is found even before the recommend replacement interval.

Replacement of consumable service parts is not covered under warranty.

Every 1 years: Master cylinder and wheel cylinder caps dust seals

OSHA-approved eye protection rated for 200kPa(30psi) is required for air cleaning operation. When changing oil, remove strainer and clean it with flushing oil. Blow dry compressed air from inside of strainer to outside and install when completely dry.

Dispose of oil in locally approved manner.

Bleed the air after checking the oil level as below;

Check for mast overhead clearance.

Fully raise and lower mast and also fully tilt it forward and backward several times.