Hyundai Forklift 35D-7E

Hydraulic oil return filter Replace

Park the truck in a level place and lower the forks.

Then stop the engine and apply the parking brake.

Change oil after removing drain plug on tank bottom

Transmission oil & filter Change

Truck for obvious damage and leaks

Warning plates and decals condition

Condition of tires and wheels. Air pressure.

Lift chain and fastener condition

Carriage or attachment and forks condition

Before using a lift truck, it is the operator's responsibility to check its condition and be sure it is safe to operate.

Check for damage and maintenance problems; have repairs made before you operate the truck.

Unusual noises or problems must be reported immediately to your supervisor or other designated authority.

Do not make repairs yourself unless you are trained in lift truck repair procedures and authorized by your employer. Have a qualified mechanic make repairs using genuine HYUNDAI or HYUNDAI-approved parts.

Do not operate a truck if it is in need of repair. If it is in an unsafe condition, remove the key and report the condition to the proper authority. If the truck becomes unsafe in any way while you are operating it, stop operating the truck, report the problem immediately, and have it corrected.

Lift trucks should be inspected every eight hours, or at the start of each shift. In general, the daily inspection should include the visual and functional checks described on the followings.

Leaking hydraulic oil may be hot or under pressure. When inspecting a lift truck, wear safety glasses and do not check for leaks with bare hands.

First, perform a visual inspection of the truck and its major components;

(1) These are the parts which the operator cannot judge the remained lifetime of them by visual inspection.

(2) Repair or replace if an abnormality of these parts is found even before the recommend replacement interval.

Replacement of consumable service parts is not covered under warranty.

Every 1 years: Master cylinder and wheel cylinder caps dust seals

OSHA-approved eye protection rated for 200kPa(30psi) is required for air cleaning operation.

Dispose of oil in locally approved manner.

Oil changed and strainer cleaned with flushing oil

Strainer dried with compressed air from inside to outside

Strainer installed when completely dry

Checked for mast overhead clearance