Hyundai Forklift 35DF-7

Hydraulic oil return filter Replace

Park the truck in a level place and lower the forks.

Then stop the engine and apply the parking brake.

Change oil after removing drain plug on tank bottom

Transmission oil & filter Change

Truck for obvious damage and leaks

Warning: This inspection requires trained personnel with PPE!

Any visible damage on the lift truck?

All capacity, safety, and warning plates or decals are attached and legible?

Any leaks of fuel, engine coolant, transmission fluid, etc. before and after starting engine?

Any hydraulic oil leaks and loose fittings?

Driver's overhead guard, load back rest and all other safety devices are in place, securely fastened and undamaged?

Any obvious wear and maintenance problems on the mast and lift chains?

Load forks are correctly installed and locked in their proper position?

Wheels and tires are safely mounted, in good condition, and have correct air pressure?

(1) These are the parts which the operator cannot judge the remained lifetime of them by visual inspection.

(2) Repair or replace if an abnormality of these parts is found even before the recommend replacement interval.

Replacement of consumable service parts is not covered under warranty.

Every 1 years: Master cylinder and wheel cylinder caps dust seals

OSHA-approved eye protection rated for 200kPa(30psi) is required for air cleaning operation. When changing oil, remove strainer and clean it with flushing oil. Blow dry compressed air from inside of strainer to outside and install when completely dry.

Dispose of oil in locally approved manner.

Bleed the air after checking the oil level as below;

Check for mast overhead clearance.

Fully raise and lower mast and also fully tilt it forward and backward several times.