Hyster-Yale Chain Hoist 0,25t/1

Warning: This inspection requires trained personnel with PPE!

Supporting structure has sufficient stability

Expected forces can be safely absorbed

Issues found during the inspection

Sign off on the attachment point inspection

Warning: This inspection requires trained personnel with PPE!

Supporting structure has sufficient stability

Enter the expected forces that can be safely absorbed by the supporting structure

Enter the details of the supporting structure

Sign off on the attachment point inspection

Warning: This check requires trained personnel!

Lift, pull or tension and lower or release a load over a short distance with the unit

When the hand chain is released, the load must be held in any position

Repeat the check at least twice

Is the brake functioning properly?

ATTENTION: If the brake does not function properly, the unit must be immediately taken out of service and the manufacturer must be contacted!

Sign off on the brake function check

Warning: This inspection requires trained personnel with PPE!

Load chain is not twisted or kinked

If the chain is twisted or kinked, report the issue to the maintenance team and stop the procedure

Is the bottom block rolled over?

If the bottom block is rolled over, untwist the chain

If the chain is not reeved correctly, reeve the chain correctly

Does the chain weld face outwards?

If the chain weld does not face outwards, adjust the chain

Warning: For safety reasons, hand chain links may only be used once.

Identified the non-welded link of the hand chain?

Enter the new length of the hand chain in mm

Did you remove or add an even number of chain links?

Used a new link to close the loose chain ends?

Hand chains are not twisted while they are fitted?

Sign off on the hand chain adjustment