Hammer Strength Linear Leg Press HSLLP

Visually inspect all hardware for loosening, tampering or wear

Check jam nut on weight stack for tightness

Inspect all accessory and or carabiner clips or connecting links for wear

Check cables for stretch and adjust as necessary by loosening the large nut on top of the weight stack and screw in the threaded plug until cable is tight and the weight stack pin goes in all holes easily. Tighten the large nut to complete the adjustment

Sign off on the machine maintenance

1. Clean Guide rods with a cotton cloth and break-free.

• Clean Guide Rods with break-free on a cloth and wipe off old residue. Clean tops of bearings at stack and inspect for heavy buildup on rods below head plate (lift half of stack and do a visual inspection, then clean as necessary).

2. Hardware should be checked for looseness. Tighten as required using metric tools.

• Inspect hardware on all machines and tighten any bolts or nuts that may have loosened over the life of the product.

Upholstery wiped down with a mild soap and water or comparable all purpose cleaner

Cables visually inspected for wear at and around connections and along entire length of cable

Cables replaced at first sign of wear

Clean Hand grips with mild soap and water

Clean Wax frames with a standard, non-abrasive, wax finish

Handgrips checked for wear or damage

All paint chips filled immediately with touch-up paint

Lubricate Guide rods with Silicone Compound (part number 3238401). Apply the lubricant to a cotton cloth, then run the cotton cloth up and down the guide rods as needed

Sign off on the machine maintenance