Fulton Companies Hydronic Boiler EDR-1500

Wear appropriate respiratory protection during burner assembly maintenance.

Ensure all maintenance procedures are completed by trained personnel.

Follow proper safety precautions when using a ladder.

Test high-limit control by reducing setting below the operating temperature; burner should shut off. After readjusting the setpoint, reset the control.

Test operating temperature control by reducing temperature setting as necessary to check burner operation.

Flue Gas and Pressure Switch Testing

Check flue gas temperature at outlet.

Ensure electrical supply to the equipment is disconnected before maintenance.

Label all wires prior to disconnection.

Ensure area is free of any combustible materials and other dangers.

Follow all proper lockout/tagout procedures for service.

Do not try to light the appliance if you smell gas.

Do not touch any electrical switch if you smell gas.

Do not use any phone in the building if you smell gas.

WARNING: All information in this manual is for reference and guidance purposes, and does not substitute for required professional training, conduct, and strict adherence to applicable jurisdictional/professional codes and regulations.

Never use open flame or other sources of ignition to check for gas leaks.

Ensure boiler is off and cooled, with proper lockout - tagout per local codes prior to service and maintenance.

CAUTION: Use caution when using any cleaning solutions. Refer to local regulations for proper cleaning solution disposal.

Do not allow dust or dirt to accumulate around the boiler.

Prepare the Annual Preventative Maintenance Kit

Wear appropriate respiratory protection

Ensure all maintenance is performed by trained personnel

Use only Fulton-provided nuts and washers

Follow proper safety precautions when using a ladder

Filter Inspection and Replacement

Remove the filter from the slot above the cabinet

Is the filter plugged or contaminated with debris?

Replace the filter if it is plugged or contaminated

Confirm that all safety warnings and procedures have been read and understood

Ensure electrical supply to the equipment is disconnected

Label all wires prior to disconnection

Ensure area is free of any combustible materials and other dangers

Follow proper lockout/tagout procedures for service