Frigidaire Refrigerator GLHS36EFSB1

Determine the type of water filter model

Has the water filter been in a refrigerator that has not been in use for a while?

PureSource (RG-100) Maintenance

Open freezer door and leave open until filter change is complete

Hold filter cup firmly and unscrew towards left

Rinse out cup under running water

Check the large o-ring in the groove inside the cup; replace if damaged

Unplug the refrigerator before replacing any light bulb

Wear gloves as protection against possible broken glass

Identify the location of the light bulb to be replaced

Remove light cover if necessary

Replace with an appliance bulb of the same wattage

Replace light cover if necessary

Clean smooth handles and exterior surfaces using soap and water and a soft cloth

Avoid using commercial household cleaners, ammonia, or alcohol to clean handles

Avoid using a dry cloth to clean smooth doors

Clean stainless steel front and handles with non-abrasive soapy water and a dishcloth

Rinse with clean water and a soft cloth

Wipe stubborn spots with an ammonia-soaked paper towel, then rinse

Use a non-abrasive stainless steel cleaner and follow manufacturer's instructions

Stop ice production by lifting the wire signal arm to the 'up' or OFF position (side mounted) or setting the On/Off power switch to 'O' (rear mounted)

Remove the ice container by lifting up and out.

Clean the container with mild detergent and rinse with clear water.

Allow the container to dry completely before replacing in the freezer.

Remove ice chips from the shelf and chute that support the ice container.

Unplug the electrical power cord from the wall outlet

Cleaning Interior and Door Liner

Prepare cleaning solution with 2 tablespoons of baking soda in 1 quart of warm water or use soap and water

Wring excess water out of sponge or cloth before cleaning around controls, light bulb, or any electrical part

Clean interior and door liner with the prepared solution

Wipe door gaskets with a clean soft cloth and soap and water