Edwards Intelligent Photoelectric Smoke Detector SIGA-PS

Verify detector is not in 'dirty detector' state

Is the detector sensitivity measurement available on the loop controller?

Print sensitivity report to satisfy NFPA requirements

Has the sensitivity measurement been conducted at the end of the first year and every two years thereafter?

Check current state of each detector via the maintenance program

Can single detectors be turned off temporarily from the control panel?

Verify if any detector shows a 'dirty detector' message.

Check if the detector's sensitivity measurement is being transmitted to the loop controller.

Print the sensitivity report to satisfy NFPA sensitivity measurements.

Review the current state of each detector and other pertinent messages on the maintenance program.

Can single detectors be turned off temporarily from the control panel?