Dulevo International Street Sweeper 6000

CAUTION: Let the engine cool down in order to avoid any risk of scalding.

Lubricate the gasket of the new oil filter and tighten it 3/4 turn by hand after gasket contacts base.

Start the engine and bring it at operating temperature (70÷80 °C).

Turn off the engine, wait a few minutes until all the oil has flown in the pan and check the oil level.

CAUTION: Check for possible oil leaks.

In case of leaks, immediately stop the engine and contact the Service Department.

NOTICE: Before starting to replace the oil, please refer to the specific instructions found in the engine handbook.

Open the right side hatch and remove the filler cap (1)

Place a pan with a capacity of approximately 15 litres under the drain plug (located on the right hand side of the machine)

Remove the drain plug (2) and let all the oil flow into the pan

Replace the engine oil filter as indicated in paragraph 6.4.b

Fill-up with new oil according to the type indicated in the “Refuelling” table enclosed in the machine documentation

Wait a few minutes for the oil to deposit, then check the level on the dipstick (3)

CAUTION: Check for possible oil leaks. In case of leaks, immediately stop the engine and contact the Service Department

CAUTION: Daily check the points listed below to keep your vehicle in good order. These checks are additional and do not replace programmed maintenance.

Visually check the systems and make sure there are no leakages.

Visually check the pressure and wear of the tires.

Make sure that the hatches are regularly closed, that the container is completely lowered and that the various vehicle parts are fastened correctly.

Check the lights and horn and make sure they work correctly.

Check the brakes and their travel; make sure they work correctly.

WARNING: In case of any malfunction or any doubt about the machine’s functionality DO NOT use it and contact the Service Department.

WARNING: Unless otherwise specified by the engine builder, the checks described hereafter must be done when the engine is cold and turned off and the vehicle is level. Furthermore, it is forbidden to smoke or use free flames.

Sign off on the daily street sweeper check

Warning: This check requires trained personnel with PPE!

Check that in the “A” area of the front and rear axle there is no oil fouling

Are there any oil leaks detected?

If oil leaks are detected, do not use the machine and apply to an authorised workshop

Sign off on the axle end reduction gear check

Enter the length of the side brush bristles in mm

Is the length of the side brush bristles above 120 mm?

Enter the length of the main brush bristles in mm

Is the length of the main brush bristles above 40 mm?

Does the main brush leave a uniform rectangular track on the ground?

Refer to paragraph 6-5 for instructions on how to adjust and replace the brushes

Sign off on the weekly brushes efficiency check