DoALL Bandsaw 3613-V5

Warning: Ensure to wear appropriate PPE before starting the procedure

Type of coolant and lubricant used

Type of oils and/or fluids used

Sign off on the bandsaw lubrication

Band Tension Screw and Bearing. Clean and apply oil.

Post, Optional Post Elevating and Gears. Clean and apply oil.

Bandwheel Slides, Hinges, and Tilt Screws. Clean and apply oil.

Table Trunnion. Oil tilt surfaces.

Miscellaneous: Slides, Hinges, Pivot Points, Component Parts, Unpainted Surfaces, etc. Clean and apply oil as required.

Accessory Equipment as Supplied. Keep clean and apply oil as required to maintain proper function, reduce wear, and corrosion, etc.

Recommended: High quality, rust and oxidation-inhibited, medium hydraulic and general purpose industrial oil.

ISO-VG Grade 68 (Formerly ASTM Grade No. 315).

Union 76, UNAX RX 68, or equivalent.

1. Wipe oil onto the post occasionally. Then move the post up and down through the slide block several times.

2. Oil the upper and idler bandwheel slides and band tension screw each month.

3. Wheel bearings are sealed and lubricated for life.

Warning: Stop the machine when cleaning the machine or opening bandwheel doors or covers.

Machine stopped before cleaning?

Bandwheel doors or covers opened safely?

Machine and its parts cleaned to prevent excessive wear and damage?

Chip drawer removed and chips disposed when necessary?

Sign off on the bandsaw cleaning

1. Reverse back-up inserts for additional wear life, then replace when all surfaces are worn.

1. These bearings are sealed and packed for life with a special lubricant.

(b) Pulling out the bearing and shaft

(c) New bearings are easily installed with a light press fit.