Daikin Air Handler CAH012GDAC

Belt tension slacked off if belts have been installed

Capscrews E loosened but not removed

Pitch diameter adjusted by opening or closing the movable flanges by half or full turns

Setscrews D and capscrews E tightened

Belt tension readjusted if belts have been installed, or belts installed and tension adjusted if not previously installed

All keys in place and all setscrews and all capscrews are tight before starting the drive

Filters removed from inside the unit

Wire clips rotated to release filters

Clean filters fully seated in the frame

Pressure drop for installed filters

Typical filter pressure drop for clean filters at rated air flow

Final pressure drop for front loaded filters

Prefilters removed to check the pressure drop of the final filters

Loosen setscrews B and C in moving parts of sheave and pull out external key E

Adjust sheave pitch diameter for desired speed

Replace external key E and securely tighten setscrews B over key and setscrews C into keyway in fixed half of the sheave

Put on belts and adjust tension

Make future adjustments by loosening the belt tension and increasing or decreasing the pitch diameter of the sheave as required

Adjust both halves of the two-groove sheaves by the same number of turns from closed position

Verify that all keys are in place and that all se screws are tight before starting drive

Check setscrews and belt tension after 24 hours service

Sign off on the Pitch Key Sheave Maintenance

WARNING: Before servicing fans, lock out and tag out all power to the unit. Fans or belts can cause severe personal injury or death

WARNING: Do not open the hinged access door and screw-fastenerd access panels while the unit is operating. Moving parts and strong suction forces can cause severe personal injury or death

Upon completion of the air balance, replace the variable pitched motor sheave with a properly sized, fixed sheave

Replace the adjustable sheaves with fixed sheaves

Measure the diameter of the V-belt outer surface where it passes around the sheave (pitch diameter)

Calculate fan speed from the motor nameplate rpm

Sign off on the fan drive maintenance

CAUTION: Bearing overheating potential. Can damage the equipment. Do not over lubricate bearings. Use only a high grade mineral grease with a 200°F safe operating temperature.

NOTE: Direct-Drive Class Il fans that are supplied with TECO motors have double shielded bearings on frame sizes 140T-280T. These bearings are pre-packed with a long life grease and are not regreaseable. Larger frame size TECO motors are regreaseable and follow the same lubrication recommendations as all other motors

Motor bearings and ball bearings lubricated

Select the type of lubricant used

Amount of lubricant used (in oz)

Motor run for five minutes after lubrication

Sign off on the motor bearings lubrication