Crown Work Assist Vehicle WAV50-84

1. Don’t charge or service the batteries unless you are trained and authorized

2. Charge batteries in areas designated for that use. Do not expose the vehicle to moisture or snow while charging. Don’t try to charge a frozen battery

3. Wear protective eyewear, gloves and clothing when servicing the batteries

Batteries can produce explosive gas. Do not smoke, use open flame, or create an arc or sparks near this battery. Ventilate well when in an enclosed area and when charging

This battery contains Sulfuric Acid which causes severe burns. Do not get in eyes, on skin, or clothing. In case of contact, flush immediately and thoroughly with water. Get medical attention if your eyes are affected

1. Turn the vehicle off or push the Emergency Disconnect button

- Check your vehicle before starting work

You must make sure your vehicle is safe, both for you and for people around you

IF ANYTHING DOESN’T LOOK OR FEEL RIGHT, DON’T DRIVE YOUR VEHICLE. REPORT THE PROBLEM TO YOUR SUPERVISOR

WALK AROUND YOUR VEHICLE & CHECK IT OVER:

1. Make sure the batteries are charged

2. Check that all wheels are in good condition

3. Look into and under the vehicle for signs of leaks

4. Turn the key to ON. See that the "beeper" and all display lights are working. Try the horn

5. Make sure the Emergency Disconnect button works

Test your vehicle in an uncongested area

Platform elevation (should not exceed 20 inches with gates open)

Vehicle drives slowly in both directions

Vehicle drives through the full speed range, in forward and reverse

In forward, and with platform lowered, the speed is slower with gates closed

Stopping distance in forward and reverse

Caution, travel speed, load weight and floor conditions can affect stopping distance