Climate Master Heat Pump GRV006AGC10CLTS

Warning: Only trained personnel should perform this check

Fan motor dry operation suspected?

If dry operation is suspected, report to the maintenance team immediately

Enter the amp draw from the serial plate data

Is amp draw no more than 10% greater than indicated on serial plate data?

Sign off on the fan motors dry operation and amperage check

Direct ground water applications only

If the system is installed in an area with a known high mineral content (125 P.P.M. or greater) in the water, it is best to establish a periodic maintenance schedule with the owner so the coil can be checked regularly.

Enter the water flow rate through the unit

All other water loop applications

Generally water coil maintenance is not needed for closed loop systems. However, if the piping is known to have high dirt or debris content, it is best to establish a periodic maintenance schedule with the owner so the water coil can be checked regularly.

CAUTION: Fin edges are sharp. Care must be taken not to damage the aluminum fins while cleaning.

Check the air coil for dirt. If dirty, proceed to next step.

Brush or vacuum clean the air coil.

Check the aluminum fins for damage.

Sign off on the air coil cleaning

Ensure that electrical power to the unit is disconnected.

Is the supply hose connected directly to the return riser valve using a single length of flexible hose?

Open all air vents. Fill the system with water. DO NOT allow system to overflow.

Is all air bled from the system?

Start the pumps, and systematically check each vent to ensure that all air is bled from the system.

Adjust makeup water as required to replace the air which was bled from the system. Check and adjust the water/air level in the expansion tank.

Upon receipt of the equipment, carefully check the shipment against the bill of lading.

Packaging of each unit inspected?

Each unit inspected for damage?

Ensure that the carrier makes proper notation of any shortages or damage on all copies of the freight bill and completes a common carrier inspection report.

Concealed damage not discovered during unloading must be reported to the carrier within 15 days of receipt of shipment. If not filed within 15 days, the freight company can deny the claim without recourse.

Date of reporting concealed damage to the carrier

NOTE: It is the responsibility of the purchaser to file all necessary claims with the carrier. Notify your equipment supplier of all damage within fifteen (15) days of shipment.