Alliance Laundry Systems Tumble Dryer UKT45N

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Remove all lint from lint compartments and lint screen.

Ensure the main supplies of electricity and water to the tumble dryer are on at all times.

Verify that the water dispensing system is not activated before operating the tumble dryer.

Confirm compliance with local codes by contacting the local water company or municipal authority.

Plumbing and Installation Verification

Ensure all plumbing connections are made by a qualified professional.

Verify that plumbing conforms to local, state, and federal regulations or codes.

Confirm that necessary water, water pressure, pipe size, and connections are provided.

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Check for potential issues affecting airflow switch operation

Is the airflow switch operating properly?

Hardware and Connections Inspection

Steam Filter and Panel Maintenance

Remove all front panels and vacuum, including coin drop mechanisms

Check cylinder and front panel seals

Inspect cabinet and inner panels for any damage, replace or repair as needed

Use a vacuum to clean air vents on drive motors.

Use a vacuum to clean lint from rear limit thermostat cover.

Check and clean steam coils, if applicable.

Check flow of combustion and ventilation air.

Check belt tension and condition. Replace worn or cracked belts.

Clean the machine's top panel with mild detergent.