Xerox Holdings Press V280

Ensure that the press is not running before performing this procedure.

Holding the staple cartridge at the position indicated by the arrow, remove it from the unit.

Insert a new staple cartridge into the unit.

Insert the unit to its original position.

Close the finisher front cover.

Sign off on the staple cartridge replacement.

Open the front door of the Business Ready Finisher

Grasp the booklet maker handle and pull the unit toward you until the staple cartridges appear on the top edge of the device

To remove the staple cartridge from the booklet maker, push down on the staple cartridge handle as shown, then pull the cartridge out and up

To permit the staple cartridge handle to open out and away from the staple refill, press in the green tabs, then pull back the handle

To remove the staple refill, press the rear of the refill container as shown

Replace the staple refill, then return the staple cartridge to the booklet maker

Close the front door of the Business Ready Finisher

Ensure that the press is not running before performing this procedure.

This procedure is applicable only for the PR Booklet Maker Finisher.

Pull out the Saddle Stitch Unit 3 toward you until it stops.

While holding the tabs on the staple cartridge, pull out the cartridge to remove it.

There are two booklet staple cartridges provided. Check the message to see which cartridge needs replacing.

While holding the tabs on the new staple cartridge, push in the cartridge until it seats.

Make sure that the marks are aligned.

Push the Saddle Stitch Unit 3 gently into the finisher until it stops.

The following items are the Customer Replaceable Units (CRU) for the press.; It is recommended that you have a supply of these items available to eliminate down time when they need to be replaced.

• Dry Ink/Toner cartridges (C, M, Y, K)

• An empty Waste Dry Ink/Toner bottle

Refer to www.xerox.com for the latest consumable part numbers.

Note The Fuser Module may be replaced by the customer only if directed to do so by Service.

Note Store supply items and Xerox parts in their original packages in a convenient location.; Always recycle/dispose the used CRU according to the disposal instructions supplied with the new CRU.

Ordering Supplies Xerox supplies, paper, and throughput material can be ordered from the web site www.xerox.com and clicking on the Supplies link.; For any item that is not orderable from the web site, contact your Xerox Service Representative.

Before you start to clean the press, be sure to switch off the power using the rear breaker switch and unplug the press.; Cleaning the press without switching off the power may cause an electric shock.

• Always use a dry lint-free cloth for all cleaning actions unless otherwise directed.

• Do not use benzene, paint thinner, other volatile liquids, or spray insect repellent on the press as doing so may discolor, deform, or crack covers.

• If a moistened cloth is used, wipe afterwards with a dry lint-free cloth.; Cleaning the press with an excessive amount of water may cause the press to malfunction and/or damage documents during printing.

Cleaning the Document Cover and Glass

b) To remove dirt, wipe the document cover with a soft cloth moistened with water and then wipe it dry with a soft cloth.; If dirt is difficult to remove, try gently wiping with a soft cloth moistened with a small amount of neutral detergent.

2.Cleaning the document (platen) glass