Trane Split System Cooling Condenser TTA201F

Preparation and Safety Precautions

Ensure all electrical connections are complete before starting the procedure.

Is the compressor access panel installed and manifold hoses routed through refrigerant gauge access holes?

Verify that a qualified licensed electrician is present for handling live electrical components.

Turn on power to the unit and allow the system to run for 5 to 10 minutes to stabilize operating conditions.

Airflow and Refrigerant Charging

Measure airflow across the indoor coil.

Is the airflow measurement within the fan performance data specifications?

Inspect individual pieces of the shipment before accepting the unit

Inspect the unit for concealed damage before storage and as soon as possible after delivery

Was concealed damage discovered?

Stop unpacking the shipment if concealed damage is discovered

Do not remove damaged material from the receiving location

Take photos of the damage if possible

Notify the carrier’s terminal of damage immediately by phone and by mail

Request an immediate joint inspection of the damage by the carrier and the consignee

Disconnect all electric power, including remote disconnects and discharge all motor start/run capacitors before servicing.

Follow proper lockout/tagout procedures to ensure the power cannot be inadvertently energized.

Verify with an appropriate voltmeter that all capacitors have discharged.

Ensure compressor is not operated or powered while under a vacuum.

Perform all of the monthly maintenance inspections.

Check unit superheat and record the reading in the 'Maintenance Log'.

Disconnect all electric power, including remote disconnects and discharge all motor start/run capacitors before servicing.

Follow proper lockout/tagout procedures to ensure the power cannot be inadvertently energized.

Verify with an appropriate voltmeter that all capacitors have discharged.

Remove enough panels from the unit to gain safe access to coils.

Straighten any bent coil fins with a fin comb.

Remove loose dirt and debris from both sides of the coil with a soft brush.

Disconnect all electric power, including remote disconnects, and discharge all motor start/run capacitors before servicing.

Follow proper lockout/tagout procedures to ensure the power cannot be inadvertently energized.

Verify with an appropriate voltmeter that all capacitors have discharged.

Ensure the compressor is not operated or powered while under a vacuum.

Monthly Maintenance Inspections

Check unit wiring to ensure all connections are tight and that the wiring insulation is intact.

Inspect the condenser coils for dirt and debris.