Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Systema Polska Hot Air Generator BC250RTPA7

Create an account to install this asset package.

Maintenance Plans for Systema Polska Hot Air Generator Model BC250RTPA7

Integrate maintenance plans directly into your work orders in MaintainX.

Burner Maximum And Fine Adjustment

Rough Adjustment

Activate the burner and adjust it to maximum thermal load.

Check the gas pressure entering the solenoid valve.

Is the gas pressure not lower than the nominal supply pressure decreased by a maximum of -20%?

Remove the cap of the maximum pressure regulator using a screwdriver.

Adjust the gas and air mixture using the Allen wrench size 3.

Check the gas pressure at the outlet of the solenoid valve.

Does the power comply with the nominal value indicated on the nameplate?

Fine Adjustment

Run this procedure

Initial 2 Hours Belt Maintenance

Safety Precautions

Ensure the appliance is disconnected from the power supply

Motor Rotation Check

Remove the V-belts by unlocking the four screws in the motor base

Is the motor rotation direction correct without load?

If incorrect, disconnect power supply and invert the two power supply phases

V-Belt Installation and Alignment

Reinstall the V-belts

Check that the pulleys are aligned

Run this procedure

Fuel Replacement

Eolo BC/BL 15÷120 RT

Shut off the gas and electricity supply

Unscrew the cap (A) from the nozzle holder fitting (C)

Unscrew the nozzle (B) located inside the fitting (C)

Choose the nozzle suitable for the type of gas used

Screw the nozzle into the housing (C)

Screw the cap (A) back on

Seal the gas valve adjustment part after calibration

Burner Start and Efficiency Check

Run this procedure

1 Yearly Hot Air Generator Maintenance

Pre-Maintenance Safety Precautions

Open the main switch by removing current and close the gas valve.

Place a warning sign on the control panel stating: 'System undergoing maintenance, IT IS FORBIDDEN to perform operations on the control panel of the appliances.'

Ensure all personnel are equipped with safety devices and individual protection.

General Maintenance Checks

Check the general condition of the device.

Check the threaded connections of the gas system and the tightness of the gaskets, replace if necessary.

Check the condition of the electrodes and the combustion head, clean if dirty.

Check the condition of the gas mixer, clean with a rag or brush if necessary.

Run this procedure

Burner Parameter Adjustment

Initial Checks

Check ignition at the minimum regulated output of the burner

CO₂ Setting Adjustment

Are there problems with ignition?