Panasonic Static Remover Fantype Ionizer ER-F12

Install a filter in accordance with the operating environment.

1 Remove the filter cover. Disengage the clasps in the places indicated by in the illustration below, and then pull the filter cover in the direction of the arrow to remove it. (Refer to the illustration below.)

2 Clean away any dust and dirt adhering to the filter. If the filter is particularly dirty, wash it in water. If washing the filter in water, let it dry thoroughly before reusing it.

3 Install the filter. Install the filter cover.

* If the device is used while the filter is still wet, accidents or problems with operation may occur.

* If the filter will not come clean, it should be replaced.

* Be careful not to let anything get inside the device while the filter is removed.

When using a ultrasonic cleaner for cleaning, remove the discharge needle unit.

● Discharge needle unit removal procedure

● Discharge needle unit installation procedure

As shown in the figure above, install the louver and the discharge needle unit so that the claw of the louver is inserted into the hole of the discharge needle unit. (Note: 3) Turn the discharge needle unit clockwise until it stops to install.