Milwaukee Power Tool 2630-20

Remove battery pack before checking the lower guard

Grasp the lower guard by the sides and push it all the way back into the blade housing

Release the lower guard and observe its operation

If the guard does not spring back immediately, clean the upper and lower guards to remove all chips and debris

Check the operation again by starting with step 1

If the guard still does not immediately spring back into place, contact a MILWAUKEE service facility for repairs

Remove battery pack before installing or removing blades

Place the saw on a flat surface with the blade facing upwards

Push in the spindle lock button

Use the wrench to turn the bolt counterclockwise

Remove the bolt and blade flange

Slide the lower guard lever up to raise the lower guard

Remove the blade from the spindle

Place a square against the blade and shoe to inspect the degree setting

Is the blade 90 degrees to the shoe?

Loosen the bevel adjusting knob

Adjust the bevel adjustment screw until the blade is at a 90 degree angle with the shoe

Unplug the charger and remove the battery pack before maintenance

Do not disassemble the tool, battery pack, or charger

Avoid immersing the tool, battery pack, or charger in liquid

Inspect the tool for the following issues

Does the tool start or operate at full power with a fully charged battery pack?

Loosen the bevel adjusting knob

Set the desired angle on the bevel scale

Tighten the bevel adjusting knob securely

Is the bevel adjusting knob securely tightened?

Is the desired angle correctly set on the bevel scale?