Lincoln Electric Welding Equipment 1450-000-U

Perform a PPE Hazard Assessment

Ensure adequate protection during maintenance and cleaning

Unplug the appliance or turn off the power supply

Avoid using a pressure washer or hose for cleaning

Use eye protection to prevent injury from airborne dust and debris

Avoid using steel wool, abrasive, or chlorine-based products

Check for scratches from wire brushes, scrapers, or steel pads

Remove any deposits left on stainless steel surfaces

Ensure no chlorides are present from table salt, food, or water

Stainless Steel Cleaning and Restoration

Use stainless steel cleaners free of phosphates, chlorine, chloride, and ammonia

Consider using True's environmentally-friendly cleaner and polish

WARNING: Risk of electrical shock or fire!

Ensure appliance is not cleaned with a pressure washer or hose

Warn customers of slippery surfaces and dry them immediately

Mark all wet floor areas with a wet floor sign

Perform a Personal Protective Equipment (PPE) Hazard Assessment

Use appropriate tools, safety equipment, and PPE during cleaning

Clean gaskets with warm soapy water

Avoid using sharp tools or knives to scrape a gasket

Visit the media center at truemfg.com for additional maintenance instructions

Verify that the appliance is level and properly supported before making adjustments

Replace components with OEM parts as shown in fig. 1

Ensure a licensed service provider services your appliance

Acknowledge that routine care and maintenance procedures are not covered by TRUE's warranty

Understand that using non-OEM components may void TRUE's warranty

Check physical condition of all gaskets

Coil Inspection and Maintenance

Check physical condition of all condenser coils

Check physical condition of all evaporator coils

Check all evaporator coils for dust and debris