John Deere Tractor 5625

Change primary and secondary air filter elements

Change transmission/hydraulic oil and Filter

Lower rockshaft to remove trapped oil

Remove drain plug from transmission case (A) and drain out oil

If equipped with MFWD axle, also remove drain plug (B) in drop housing

Replace filter (C) while changing oil. Apply a film of oil to new filter gasket and install new filter. Hand tighten only

Refill system with transmission-hydraulic oil. (See Fuels, Lubricants and Coolant section)

Wait 5 minutes and check oil level at dipstick (D)

Replace Primary and Secondary Air Filter Elements

Open hood and remove right-side grill panel

Remove air cleaner retaining strap (A)

Release three air cleaner cover retaining clips (B) and remove air cleaner cover (C)

Remove primary (D) and secondary (E) elements

Before you install primary element, clean the inside of air cleaner housing and unloader valve with a damp cloth

Check level in coolant tank (B)

If engine is cool and level is below 'LOW', add coolant to recovery tank to bring to 'LOW'

Check oil level on dipstick (A). Oil level should be between two marks on dipstick

If level is low, add oil through oil filler hole (B) until even with upper mark. DO NOT over fill

Fill fuel tank and add diesel conditioner

Drain water and sediment from fuel tank

Transmission/hydraulic filter replaced?

Sign off on the 100 hourly maintenance

Drain coolant from radiator and engine block

Tighten cap screws to 47 N.m (35 lb-ft)

Flush system with Radiator Cleaner

Replace thermostat and tighten cap screws to 47 N.m (35 lb-ft)

Re-check coolant level and add make-up coolant as needed