Hussmann Island and Multi-deck Island SI2

Warning: This procedure should be performed by a trained technician only to prevent damage to the coil or electrical components.

Electrical power to the merchandiser disconnected?

Shelves, display racks, deck pans, CAD gusset, and canopy light channel removed?

Panels attached to CAD tower removed?

Waste outlets verified open and drip piping not blocked? Loose debris removed?

Unpressurized stream of water used to wash baffles in the CAD tower? Water not introduced faster than drain can handle?

Coil and fans cleaned as necessary?

All surfaces clean and dry, reassembled in reverse order?

Warning: Disconnect the electrical power to the merchandiser before starting the cleaning process

Electrical power to the merchandiser disconnected

Compressed air applied to the moiré of the CAD

Interior wiped down with a soft cloth

Was a mild detergent and sanitizing solution used?

Power to merchandiser turned on

Long life and satisfactory performance of any equipment is dependent upon the care it receives. To ensure long life, proper sanitation and minimum maintenance costs, these merchandisers should be thoroughly cleaned, all debris removed and the interiors washed down, weekly.

Allow the case to cool for at least 45 minutes before cleaning.

ALWAYS SHUT POWER OFF DURING CLEANING PROCESS.

Fans should be shut off at the source. All deck pans and air grilles are removable.

Coil fins are sharp and pose risk of bodily injury - use extreme care when cleaning around them.

Warning: Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component. This includes, but is not limited to, such items as fans, heaters, thermostats and lights.

Drill with a 17/8-in. (48 mm) hole saw to drill out the bottom of the drain fitting. Be sure to drill completely through fitting and bottom liner.

Apply teflon tape to threaded end of adapter and screw into threaded end of tee.

Apply an ABS and PVC compatible primer and sealer to adapter and inside of drain. Insert adapter into drain fitting.

Sign off on the drain fitting replacement

WARNING: Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component. This includes, but is not limited to, such items as fans, heaters, thermostats and lights.

Power to the merchandiser disconnected

Side splashguard and base panels removed

Ballast replaced and parts reassembled in reverse order

Sign off on the ballast replacement