Husky 60-Gallon Stationary Air Compressor C601H

NOTICE: All compressed air systems generate condensate that accumulates in any drain point (e.g., tanks, filter, aftercoolers, dryers). This condensate contains lubricating oil and/or substances which may be regulated and must be disposed of in accordance with local, state, and federal laws and regulations.

NOTICE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.

Set the Auto/Off switch to “Off”.

Slowly bleed the air from the air tank and air distribution system until tank pressure is approximately 20 psi.

Drain water from air tank by opening drain valve on bottom of tank.

After the water has been drained, close the drain valve. The air compressor can now be stored.

Sign off on the daily tank draining

WARNING: Do not allow brake fluids, gasoline, petroleum based products, etc., to come in contact with plastic parts. Chemicals can weaken or destroy plastic which, may result in serious personal injury.

WARNING: When servicing, use only identical Husky replacement parts. Use of any other parts may create a hazard or cause product damage.

WARNING: Always disconnect the air compressor from the power supply, release all pressure, and allow it to cool before cleaning or making repairs on the air compressor.

Inspect the tank annually for rust, pin holes, or other imperfections that could cause it to become unsafe.

Sign off on the tank inspection

Warning: This procedure should be performed by trained personnel only

Are the air compressor pump head bolts properly torqued?

Enter the torque of the head bolts in ft.-lbs.

Sign off on the air compressor head bolts torque check

WARNING: Hot surfaces. Risk of burn. Compressor heads are exposed when filter cover is removed. Allow compressor to cool prior to servicing.

CAUTION: Keep the air filter clean at all times. Do not operate the air compressor with the air filter removed. A dirty air filter will not allow the air compressor to operate at full capacity. Keep the air filter clean at all times.

Remove the air filter from filter cover.

Place new air filter into filter cover.

Replace air filter cover to pump.

Sign off on the air filter replacement

Turn air compressor off, lock out the power supply, and relieve all air pressure from the air tank.

Apply a soap solution to all air line fittings and connections/piping.

NOTICE: Even minor leaks can cause the air compressor to overwork, resulting in premature breakdown or inadequate performance.

Sign off on the air lines and fittings inspection