Hobart More HL600

WARNING! Disconnect the electrical power to the mixer and follow lockout / tagout procedures

New mixer bowls and accessories (beaters, whips, and dough arms) should be thoroughly washed with hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution and thoroughly rinsed with clear water before being used

The mixer should be thoroughly cleaned daily. DO NOT use a hose to clean the mixer; it should be washed with a clean, damp cloth. The base allows ample room for cleaning under the mixer. The apron may be removed for cleaning by loosening the thumb screws. DO NOT wipe down slideways when cleaning

The drip cup-splash guard assembly should be removed periodically and wiped clean

For cleaning the wire cage refer to the Wire Cage section

Sign off on the daily mixer cleaning

- Inspect regularly mixer's safety system

- Regular inspection of the mixer's safety system is necessary to check the operation of the wire cage and bowl support interlock switches.

- Inspections must be performed no less than once a year.

- For continued safe and reliable operation of this mixer, it is recommended that servicing is only carried out by Hobart trained service personnel

WARNING! Disconnect the electrical power to the mixer and follow lockout / tagout procedures

WARNING! Do not remove any covers or loosen any fittings while the mixer is operating

Ensure the electrical supply has been isolated before attempting to service or move the mixer

WARNING! The electronic drive control is fitted with high voltage capacitors. Isolate the mixer from the mains and allow the capacitors to discharge for 5 minutes before removing any covers

WARNING! Only Hobart trained service personnel or other properly trained and qualified personnel should carry out service

- Inspect the transmission belt yearly for wear and replace by a Hobart Service Technician if worn

1. To check the oil level, remove the top cover, which is secured by two screws

2. Remove the Transmission Fill Plug and check the oil level

3. If the oil level is below the line on the oil dipstick, add a small amount of the recommended transmission oil until it returns to the proper level

4. Do not overfill the transmission, as leakage may result. Contact your local Hobart Service Office for the recommended transmission oil;

Lowered the bowl support and removed the apron?

Applied a thin coat of Lubriplate 630AA on the bowl pad area of the bowl supports and on each slideway?

Note: Occasionally, the planetary seal may become dry and begin to squeak.

Worked a little lubrication (mineral oil) under the lip of the seal?

The agitator shaft should be lubricated twice a year.

Applied a thin coat of mineral oil on the agitator shaft?

Sign off on the slideways maintenance

Enter the clearance between the bottom of the bowl and the agitator in mm

Bowl and beater not coming into contact before the bowl support reaches its stop

Adjust the Bowl/Agitator Clearance

Locking nut tightened while holding the stop screw