Genie Super Lift SL-25

- Inspect the Operator's Manual

Maintaining the operator's manual in good condition is essential to safe machine operation.; The operator's manual is included with each machine and should be stored in the box provided on the mast.; An illegible or missing manual will not provide safety and operational information necessary for a safe operating condition.

1 Check to make sure the operator's manual is present and complete in the storage container on the mast.

2 Examine the pages of the manual to be sure that they are legible and in good condition.

3 Always return the manual to the storage container after use.

Notice; Contact your authorized Genie distributor or Genie Industries if a replacement manual is needed.

- Inspect the Decals and Placards

Maintaining all of the safety and instructional decals and placards in good condition is essential for safe machine operation.; Decals alert operators and personnel to the many possible hazards associated with using this machine.

They also provide users with operation and maintenance information.; An illegible decal will fail to alert personnel of a procedure or hazard and could result in unsafe operating conditions.

- Inspect the Column Hold Down System

Detection of damage to the column hold down system is essential for safe machine operation.; An unsafe working condition exists if the system is damaged and does not operate properly.

1 Using proper lifting techniques, lay the machine back against a sawhorse or other suitable support.

2 Visually inspect the hold down latches for damage.

3 Move each hold down latch back and forth to ensure that the latch moves freely.

Weld inspections are essential to safe machine operation and good machine performance.; Failure to locate and repair damage may result in an unsafe operating condition.

1 Visually inspect the welds in the following locations:

Lubricate the Casters and Wheels

Extremely dirty conditions may require that the casters and wheels be inspected and lubricated more often.

1 Visually inspect each caster and wheel for cuts, cracks or unusual wear.

2 Move the machine on a flat smooth surface and check that the casters and wheels roll smoothly, free of hesitation and binding.

3 Pump grease into the caster or wheel until it can be seen coming out of the bearing gap.

- Inspect the Mast Assembly for Wear

Detection of excessive or unusual wear in the mast assembly is essential for safe machine operation.; An unsafe working condition exists if the mast assembly has excessive wear and/or does not operate smoothly, free of hesitation and binding.

1 Attach an overhead crane or similar lifting device to the lifting bracket on the mast.