Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Genie Super Lift SL-10

Create an account to install this asset package.

Maintenance Plans for Genie Super Lift Model SL-10

Integrate maintenance plans directly into your work orders in MaintainX.

1 Daily Lift Maintenance

Inspect the Operator's Manual

Check to make sure the operator's manual is present and complete in the storage container on the mast.

Examine the pages of the manual to be sure that they are legible and in good condition.

Inspect the Decals and Placards

Refer to the decals section in the operator's manual and use the decal list and illustration to determine that all decals and placards are in place.

Inspect all decals for legibility and damage.

Inspect for Damage, Loose or Missing Parts

Inspect the entire machine for damage and improperly installed or missing parts.

Check the Winch Operation

Run this procedure

1 Yearly Lift Maintenance

Lubricate the Casters and Wheels

Extremely dirty conditions may require that the casters and wheels be inspected and lubricated more often.

1 Visually inspect each caster and wheel for cuts, cracks or unusual wear.

2 Move the machine on a flat smooth surface and check that the casters and wheels roll smoothly, free of hesitation and binding.

3 Pump grease into the caster or wheel until it can be seen coming out of the bearing gap.

Grease Type - Lithium-based

- Inspect the Mast Assembly for Wear

Detection of excessive or unusual wear in the mast assembly is essential for safe machine operation.; An unsafe working condition exists if the mast assembly has excessive wear and/or does not operate smoothly, free of hesitation and binding.

1 Attach an overhead crane or similar lifting device to the lifting bracket on the mast.

Run this procedure

150 Hourly / 3 Monthly Lift Maintenance

- Inspect the Column Hold Down System

Detection of damage to the column hold down system is essential for safe machine operation.; An unsafe working condition exists if the system is damaged and does not operate properly.

1 Using proper lifting techniques, lay the machine back against a sawhorse or other suitable support.

2 Visually inspect the hold down latches for damage.

3 Move each hold down latch back and forth to ensure that the latch moves freely.

- Inspect All Welds

Weld inspections are essential to safe machine operation and good machine performance.; Failure to locate and repair damage may result in an unsafe operating condition.

1 Visually inspect the welds in the following locations:

- winch mounting plate

Run this procedure