GEA Hygienic Pump Hilge SIPLA HT ADAPTA 18.1

Warning: This procedure requires trained personnel with PPE!

Enter the machine's operating hours

If operating hours are less than 1500, stop the procedure

If V-rings are damaged, replace them

Upload a photo of the greased V-rings

Sign off on the V-rings greasing

Warning: This inspection requires trained personnel with PPE!

Functionality check of the pump

After 2000 hours of operation, check the following:

During disassembly of the pump, check the following:

Warning: This procedure requires trained personnel with PPE!

Enter the machine's operating hours

If operating hours are above 5000, proceed with the bearing replacement

Select the type of external influence

Sign off on the bearing replacement

All connections are firmly secured

All safety devices are installed

Electrical connections are correct

Pipe system on the installation side is clean

Stop valves in the system are open

Pump along with the system is filled

Pump along with the system is vented

For double mechanical seal / quench version, flushing fluid is connected without pressure (max. 0.2bar)

Suction-side stop valve is fully open

Warning: This cleaning procedure requires trained personnel with PPE!

Cleaning is carried out inside the system no parts need to be removed or dismantled.

In general, a distinction is made between CIP and SIP. The procedures must comply with the state of the art and the EC directives.

Use only suitable cleaning agents.

Observe the safety instructions in the product descriptions of the cleaning agents.

Use always suitable personal protective equipment when handling cleaning agents.

Be sure to avoid exceeding the permissible concentrations of cleaning agents.

Reducing acids should not be used, because they cause pitting.