Gardner Denver Rotary Gas Compressor SSY

Shut down compressor and relieve system of all pressure

Disconnect, tag, and lockout power supply to the starter

Ensure no gas pressure is in the oil reservoir

Refer to OEM Packager’s instructions for specific unit details

Ensure the following components are not disturbed

Use only the replacement element shown on the filter tag or refer to the parts list for the part number

Note if oil consumption is high and refer to OEM Packager's Instructions

Check discharge pressure and temperature

Drain the moisture trap in the control system, if applicable

Observe all shutdown and lockout procedures

Refer to OEM Packager’s instructions for lubricant upgrade

Drain oil from compressor and cooler while hot

Break low points connections and drain oil from pipe runs

Dump oil from filter and reinstall used filter

Fill the system with a 50 percent charge of the new lubricant

Ensure the unit is completely off and no gas pressure is in the oil reservoir.

Disconnect, tag, and lockout the power supply to the starter.

Wipe away all dirt around the oil filler plug.

Add oil to return the oil level to the center of the run range when the unit is operating.

Replace the oil filler plug before restoring power to the unit.

Check oil level in the reservoir

Is the oil level within the operating range during full load and normal pressure?

Add oil if necessary to reach the top of the operating range

Ensure no oil is drained to correct the level

Stop the unit and release pressure before removing the oil filler plug

Inspect the scrubber to ensure it is clean

Ensure the inlet line is tight and clean