Donaldson Cabinet Collector 80 CAB

The drum pack is designed to fit a customer-supplied, standard 55-gallon drum and provides easy access for dust removal and disposal. A flexible hose connects the drum cover to the hopper. Placing a pallet under the drum allows heavier materials to be moved quickly using a forklift or pallet jack. If a pallet is used, the length of flexible hose may need to be shortened.

Sharp edge of slide gate may result in personal injury while closing the slide gate. Keep hands clear when operating the slide gate.

1. Place the 1/8-inch gasket spacer between the hopper flange and slide gate as shown.

2. Attach the drum pack and slide gate to the hopper flange using 3/8-16 bolts, washers, and hex nuts.

3. Attach the drum cover to the 55-gallon drum.

4. Use latches to secure the cover to the drum, if equipped.

5. Connect the flexible hose between the drum cover and slide gate. Secure with hose clamps.

Apply sealant to the hopper flange or the pail cover mounting plate flange toward the inside edge of the bolt pattern

Fasten the pail pack to the hopper using the bolts, washers, and nuts supplied

Place pail beneath seater mechanism

Tighten clamps on either side by pulling down

Warning: This procedure requires trained personnel with PPE!

Upload a photo of the non-combustible cloth placed over the filters

Enter the diameter of the drill bit used

Eight holes drilled in the collector top as shown

Attenuator assembly positioned and holes aligned

Number of 1/4-20 thread-cutting screws used to fasten the attenuator assembly

Cloth protecting the filters carefully removed

Top door assembly replaced and tightened securely by hand

Instruct all personnel on safe use and maintenance procedures.

Use proper equipment and adopt all safety precautions needed for servicing equipment.

Use appropriate access equipment and procedures. Note the standard collector is not equipped with access platforms unless noted on the specification drawings.

Electrical service or maintenance work must be performed by a qualified electrician and comply with all applicable national and local codes.

Turn power off and lock out electrical power sources before performing service or maintenance work.

Do not install in classified hazardous atmospheres without an enclosure rated for the application.

1. Monitor the physical condition of the collector and repair or replace any damaged components.

Routine inspections will minimize downtime and maintain optimum system performance. This is particularly important on continuous-duty applications.

Chamber silencer placed over the clean-air outlet on top of the collector

Silencer positioned flush with the front of the collector and the exhaust opening facing the front

Sign off on the chamber silencer maintenance