Crown Stockpicker SP3205

Test drive in an uncongested area

Drive the truck slowly in both directions

Drive through the full speed range in both forward and reverse

Check braking and plugging distances in forward and reverse

Know the distance it takes to stop before you start working

If anything doesn't look, work or feel right, don't drive the truck

WHEN YOU INSTALL OR CHANGE INDUSTRIAL BATTERIES:

- Turn the truck OFF. Check that all controls are in neutral

- Make certain you use the correct size and weight battery. Never operate a truck that has an underweight or undersize battery installed

- Use a roller stand to install or remove a battery. Make sure the roller stand is the same height as the rollers in the truck's battery compartment. Also make sure the roller stand is at least as long as your battery

- Never let anything metal touch the top of the cells

You could cause sparks or do damage to the battery

Use an insulator (such as plywood) when necessary

- Use an approved spreader bar to place a battery on, or remove it from a stand. Make sure you adjust the spreader bar hooks to fit the battery

Harness, tether, snap hooks and mounting points are in good condition

Safety shield is clean and clear

Battery is charged, water level is OK and vent caps are in place

Battery retainers on both sides of the truck are properly installed

All wheels are in good condition

Both forks are secure and not bent, cracked or badly worn

No signs of hydraulic leaks under the truck