Cornelius Ice Cooled Dispenser CB2323 100 lbs

Clean around Carbonator tank opening removing all silicone, and make sure cavity is clean and dry

Place new Carbonator in place of the old one

Reconnect probe wire harness to pump and motor

Seal top of Carbonator with silicone

Connect the CO2 line from the barbed fitting Carbonator and tighten to 80+/- 10 in pounds (Note: replace white gasket)

Reconnect the Carbonator lines to the Carbonator

Reinstall valve body, back cover and front cover of the valve No. 8 to unit

Turn on the CO2 supply that is connected to the Carbonator

Turn on the water supply that is connected to the pump and motor

Upon delivery inspect the unit for damage or irregularities and immediately report problems to the delivering carrier and file a claim with that carrier.

Unit inspected for damage or irregularities

Open loose parts packages and inspect parts.

Report any problems found with parts

Make sure all items are present.

Power disconnected from the unit and pump and motor

Cup Rest, Splash Panel, Drip Tray, Sliding Lid and Sanitary Plate removed

Pressure relieved in the system

Front cover, back cover and valve body of No. 8 removed

Plug button removed and hole covered with tape

Barb fitting for the CO2 line disconnected

Prepare a mild detergent soap solution in 100°F potable water

Using a nylon (not wire) bristle brush, clean the cold plate and the interior of the ice bin with the soap solution

Rinse the cold plate and interior bin surfaces with clean potable water

Using a mechanical spray bottle, prepare a sanitizing solution according to the manufacture’s directions and spray the entire interior bin surfaces. Allow to air dry

Sign off on the ice bin cleaning