Clark Forklift C20D

Clean or replace engine air filter (GAS/LPG)

Replace transmission oil C15-35

Check / lubricate steer axle wheel bearings

Replace hydraulic sump oil and hydraulic oil filter

Check injection nozzles and injection timing (diesel engine)

Sign off on the forklift maintenance

Check the tightening torque of critical fastening elements

Grease steering tie rods and steering knuckle

Cleaning, checking and lubricating the upright inside rails, rollers and side loader

Check the air intake system for leaks

Check ignition timing and contacts

Carry out an extraordinary check of the LPG system

Replace fuel filter element (Diesel)

Replace transmission oil filter C40-80

Replace drive axle oil - GTS20-30,C40-80

Sign off on the forklift maintenance

Warning: This inspection requires trained personnel with knowledge of LPG systems!

LPG system in operationally safe state?

Change the engine oil / Replace engine oil filter

Grease the sealing ring on the new filter cartridge and screw in the cartridge until it is hand tight

Remove the oil pan drain plug to drain old oil after the truck has been in operation and the engine (oil) is at operating temperature

Check for leaks after changing oil and installing new filter

Always check that your forklift-truck is operationally safe. Never drive a forklift-truck you have not check.

Walk around your forklift truck and look for any obvious signs of damage, leaks and dirt.

• The degree to which cleaning is required depends on the operating environment of the forklift truck. For operation in areas with large amounts of dust or paper, thorough cleaning is required after each operating shift, or several times a day. The same applies to operation with cement and chemicals.

Checking the LPG system for leaks and damage

• Check the system for leaks (smell of gas). Always carry out a leak test after changing LPG tank.

Check the gas hoses for damage.