The Case Compact Tractor 2310 is a versatile and efficient piece of equipment designed for various agricultural and landscaping tasks. Known for its reliability and ease of use, this tractor is ideal for small to medium-sized operations, ensuring optimal performance and productivity in the field.

Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant

PDF MANUAL

Manual for Case Compact Tractor 2310

MAINTENANCE RESOURCES

Complete asset maintenance, one click away

Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Case Compact Tractor 2310

Create an account to install this asset package.

Maintenance Plans for Case Compact Tractor Model 2310

Integrate maintenance plans directly into your work orders in MaintainX.

100 Hourly Crawler Excavator Inspection

Breaker Contact Points Check

Are the breaker contact points worn out?

Describe the wear and adjustment of the breaker contact points

Visual Inspection

Are the contact points light gray?

If not, describe the color of the contact points

Causes of Blue Contact Points

Check if any of the following causes are present

Contact Surface Wear

Run this procedure

25 Hourly / 1 Weekly Compact Tractor Inspection

Battery terminals and cables in good condition

Describe the condition of the battery tray, holdown terminals and cable ends

Is the battery case cracked or leaking?

Is the top sealing compound leaking?

Are the vent holes in the filler caps open?

Electrolyte level

Are the plates exposed?

Amount of water added to the battery

Is the case leaking or regulator overcharging?

Run this procedure

Battery Bench Load Test

Warning: Ensure the battery is disconnected from the tractor before proceeding

Initial voltage reading from the volt meter

Connect a load equal to 3 times the amp hour rating of the battery

Voltage reading after 15 seconds

Is the voltage reading less than 9.5 volts?

Battery needs replacement?

Sign off on the battery bench load test

Run this procedure

Battery Cranking Voltage Test

To perform the cranking voltage check

NOTE On Spark Ignition engines remove the center coil wire to prevent engine from starting

1. Connect a volt meter (12 volt) between the positive and negative terminals of the battery, Figure F-5, Crank the engine for 15 seconds and record voltage.

2.Connect voltmeter (12 volt) between the starter generator"A" terminal and ground on starter generator frame, Figure F-5.

Crank the engine and record voltage. If voltage is not the same or varies more than .5 volt, check the battery cables, clean and tighten connections.;

Run this procedure

Generator Output Check

Ensure the drive belt is adjusted properly.

Disconnect all cables and wires to generator.

Connect ammeter and variable resistance in series between the 'A' terminal and generator frame.

Connect voltmeter from the 'A' terminal to the frame.

Install jumper lead from the 'F' terminal to the frame.

Drive the unit at specified RPM.

Adjust to specified voltage by varying the resistance.

Is the ammeter reading lower than specified amperage?

If amperage output is too high, disconnect the jumper lead from the field 'F' terminal.

Run this procedure